HP 3000 Manuals

Information Access Server: Learning the Administrator Utility

A : Setting Up Access Server 

The lessons in this tutorial are the second stage of the five-stage
process of setting up (or updating) Access Server.

If you are taking this tutorial as part of setting up Access Server
(discussed fully in the "Before You Begin" section of the Information 
Access Server:  Planning and Configuring manual) here's a review of where
you are in the five-stage process:

	       Click here to view figure.
          Figure 2-1.  Setting Up Access Server:  Five Stages 

Before you begin the hands-on exercises in this lesson, make sure you
have completed Stage 1 of the setting up process:

   *   Have your System Manager install Access Server on the host HP
       3000.  Installation instructions are in Chapter 3 of the
       Information Access Server:  System Management manual.

   *   We recommend that you then secure the Administrator Utility.
       Instructions are in the "Before You Begin" section of the
       Information Access Server:  Planning and Configuring manual.

After you complete all six lessons, proceed to Stages 3, 4, and 5, in
which you'll plan a configuration for your system, adjust the data
dictionary if necessary, and configure Access Server according to your
plan.

Once Access Server is set up, others needing to learn the Administrator
Utility can use this manual on a stand-alone basis.

MPE/iX 5.0 Documentation