5.16 Rerunning HPINSTAL

Remount the CSLT created by HPINSTAL.

Reinvoke HPINSTAL and resume previous installation.

:HPINSTAL

If you are performing an Add-on or Update task, go to Step 4.

If you are performing a Modify Remote System task, go to Step 5.

Resume previous installation.

However, if you accidentally responded NO, you can continue by performing the following:

If you are applying a CSLT to a Remote system, go to Step 6.

If you are performing an Add-on or Update task for the local system only, go to Step 8.

Deny any previous installation, if it exists.

Type NO at the prompt.

If you are modifying a remote system (the CSLT was created on a local system) and the following message displays, it indicates that HPINSTAL located an old audit trail of an incomplete installation (that is, HPINSTFL.INSTALL.SYS). You must respond NO to properly complete your remote installation task.

From the HPINSTAL menu, select option 5, "Complete the update of this system using a CSLT created on another system," to start the update process on the remote system.

1 Update this system
2 Update this system and install patches from a PowerPatch tape
3 Create a CSLT for another system
4 Create a CSLT with PowerPatch patches for another system
5 Complete the update of this system using a CSLT created on
  another system
6 Add SUBSYS products to this system
7 Add SUBSYS products and install patches from a Powerpatch
  tape
 
Enter your choice >>5

Go to Step 8.

Restore the STORE portion of the CSLT.

Mount the CSLT tape and put the tape drive online. If using DDS tape, remove the tape and reinsert it now.

Mount the CSLT and put the tape drive ONLINE.
Skipping system files...
The HP-supported software files will be restored.

The system then restores files, processes STORE files, creates the accounting structure, and processes installation files.

FILES RESTORED.
The SUBSYS tape has been successfully restored.
Processing STORE Files . . .
DONE
DONE

The time it takes to restore the software files varies depending on which specific subsystems you have on your system.

Follow any additional instructions displayed on the screen. Reply to tape requests, if necessary.

When HPINSTAL finishes the task, you will see the following message:

The installation is now complete.

Install products that cannot be installed automatically.

Refer to the list of products in Appendix A “Manually Installed Products” and follow the directions on installing these products.