 |
» |
|
|
|
To reboot and restart the system: Shut down the
system. Reset the system after
the last shutdown message (SHUT6). If you have
an HP e3000 Series 991, 995 or 99x, connect to the service processor
before you can restart the system. Type the following: Enter
Y
to
HARD BOOT
the computer system. Do not respond to the question,
Press any key within
10 seconds to cancel boot with this
configuration
. After 5 to 10 minutes of system activity, the
Processor Dependent Code (PDC) screen displays. For HP e3000 N-Class, A-Class
Service Processor login:
Service Processor password:
|
If you get the following prompt, then enter the characters 'Ctrl-E
c f' to gain write access to the GSP.
[Read only - use ^Ecf for console write access.]
|
Enter the following commands to reset the system: If the system does not respond to the
CTRL-B
entry within ten seconds, press the reset button,
key switch, or on/off switch as appropriate for your system. The
system will halt, and then restart automatically. Enter
Y
to confirm restarting the system.
Boot the system
from the primary
boot path. Boot messages can vary, depending on the system model. If you have
AUTOBOOT
enabled, the system boots from the primary boot
path automatically, if you do not override
AUTOBOOT
. If your system prompts to enter the boot path, enter
the primary boot path. For Model 9x8LX, 9x8RX, N-Class, A-Class or 9x9KS
systems, type
BO
at the PDC screen to boot from the primary boot
path. If your system prompts,
Boot from primary
boot path?
, enter
Y
. Enter
Y
to the
Interact with IPL?
prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt
displays. At the ISL
prompt, enter: Confirm the date and time. If the date and time
displayed are not correct, enter
N
, and enter the correct date and time. If you do
not respond within 15 seconds, the system continues.
MPE/iX launch facility
Initialize_genesis - Version: <<870204.1552>>
TUE,
APR 19, 1994, 10:20:03 AM (y/n)?
Y/N
[CDM]
n n n n
Initialize genesis completed.
|
The system displays initialization and
restore messages for 5 to 6 minutes. During the start-up process, the system makes several configuration
checks and may display warning messages or error messages (for example,
error messages referencing the
SPUINFOP
file or DCC error messages). This is normal for
system start-up and will not affect system operation. At completion, it logs on as
OPERATOR.SYS
. Performing the Final Reboot
completed. Go to the next section on your checklist.
|
Printable version
