Configuration for SNA IMF/V

Figure 7-1 “SNA IMF/V Pass Thru Over an X.25 Network” illustrates the relationship among devices configured to run SNA IMF/V Pass Thru over X.25 and SNA networks.

Figure 7-1 SNA IMF/V Pass Thru Over an X.25 Network




	NOTE: To run SNA IMF/V Pass Thru over X.25, you must have the NS X.25 3000/V Link product, release V.4 or later.

No special configuration is required to run Pass Thru over an X.25 network; however, make sure all necessary information is properly configured in each of the following areas:

MPE V I/O Configuration. Use the SYSDUMP utility to verify that all PAD terminals and printers are correctly configured for I/O. In the NS X.25 3000/V Link Guide, see "NS X.25 Installation and System Configuration," for I/O configuration of PAD devices.
NS X.25 Node Configuration. Use the NMMGR utility to verify that all PAD terminals and printers are correctly configured in the Network Configuration File. In the NS X.25 3000/V Link Guide, see "NS X.25 Node Configuration," for configuration of PAD devices.
PAD Terminal Configuration. Make sure any PAD terminals that will be used to run Pass Thru are configured properly. In the NS X.25 3000/V Link Guide, see"X.25 PAD Support," for proper configuration of PAD terminals.

Configuration for SNA IMF/V

Technical documentation

» Table of Contents

» Glossary

» Index