Configuration for SNA IMF/XL

Figure 7-2 “SNA IMF/XL Pass Thru Over an X.25 Network” illustrates the relationship among devices configured to run SNA IMF/XL Pass Thru over X.25 and SNA networks.

Figure 7-2 SNA IMF/XL Pass Thru Over an X.25 Network

No special configuration is required to run Pass Thru over an X.25 network; however, make sure all necessary information is properly configured in each of the following areas:

LAN configuration. Make sure the Datacommunications and Terminal Controller (DTC) is a properly configured node on the Local Area Network. See the NS 3000/XL Local Area Network Configuration Guide for information on LAN configuration.
DTC X.25 Network Access configuration. Make sure that DTC X.25 Network Access is properly configured to communicate with the PAD devices on the X.25 network. For information on configuring DTC X.25 Network Access, see the X.25 XL System Access Configuration Guide and Using OpenView DTC Manager.
NOTE: You must have the X.25 XL System Access software installed on each MPE XL system that will be connected to the X.25 network.
PAD Terminal Configuration. Make sure any PAD terminals that will be used to run Pass Thru are configured properly. For information on PAD device configuration, see Configuring Systems for Terminals, Printers, and Other Serial Devices and Using OpenView DTC Manager.

For an overview of DTC functionality, and for a list of documentation related to DTC configuration and operation, see Getting Started with the DTC: An Overview.

Configuration for SNA IMF/XL

Technical documentation

» Table of Contents

» Glossary

» Index