HP-UX Manual Reference Pages

osiadmin(1M), the OSI Administration program, gives you access to the various configuration, administration, and diagnostic tools to setup and maintain OTS/ 9000.

osiconf(1M), and interactive configuration tool, allows you to verify and modify configuration information between OTS and FTAM.

osiconfchk(1M) allows you to verify the correctness of configuration files prior to actually starting the OSI stack.

osidiag(1M) initializes all the FDDI network interfaces on a system and connects to the FDDI network.

osiping(1M) sends a CLNP echo request to specified network hosts for testing and debugging. (Only versions of HP OTS/9000 at C.05.02 and later respond to osiping.)

osistart(1M) allows you to start OSI services, such as FTAM and X.400.

osistop(1M) allows you to stop OSI services, such as FTAM and X.400.

otsaddes(1M) adds a single end system entry to the specified subnet.

otsaddis(1M) adds a single intermediate system entry to the specified subnetwork.

otsaddnsap(1M) adds a local NSAP to OTS configuration.

otsaddroute(1M) adds a single route entry for the specified subnetwork.

otsdeles(1M) deletes the specified end system entry.

otsdelis(1M) deletes the specified intermediate system entry.

otsdelnsap(1M) deletes a local NSAP from OTS configuration.

otsdelroute(1M) deletes the specified route entry.

otsshowes(1M) displays all end system entries for the specified subnetwork.

otsshowis(1M) displays all intermediate system entries for the specified subnetwork.

otsshownsaps(1M) provides the NSAPs configured for a given network service..

otsshowroute(1M) displays all route entries for the specified subnetwork.

otsstart(1M) starts the protocol subsystems and the CONS and CLNS parts of the network layer.

otsstat(1M)shows if OTS/9000 is running and whether the OTS/9000 subsystem can successfully communicate with the X.25 and LAN software.

otsupdate(1) incorporates the configuration changes you've made to "dynamic" parameters while OTS/9000 is running.