This section contains information about the NMMGR
configuration screens that are common to all network interfaces.
The network transport configuration branch of NMMGR begins with
a screen called the Network Transport Configuration Selection screen. Figure 4-1 “Network Transport Configuration Screen
Flow” shows the screen flow for configuring the
Network Transport Configuration screens. Screens unique to the Network
Transport Configuration are indicated by bold boxed screens. [FUNCTION] denotes the function key used at a screen to invoke the
next screen on the screen flow
The Network Transport Configuration Selection screen allows
you to define global parameters for the node as well as network
interfaces of type LAN, ROUTER (point-to-point), X.25, SNA, TOKEN
(Token Ring), FDDI, 100VG-AnyLAN, 100Base-T, Gateway Half, or Loopback.
To reach the network transport configuration screens, run
NMMGR, and refer to the following pages of this section for a step-by-step process.
Step-by-Step Process:
Run NMMGR. The Open Configuration/Directory
File screen is displayed.
Enter the configuration file name (NMCONFIG.PUB.SYS) and password, if a password is required, and
press the [Open Config] function key. If you have not yet created the configuration
file you will need to press the key a second time. The Main screen
is displayed.
Press the [NS] function key. The NS Configuration screen is displayed.
Press the [Unguided Config] function key. The Unguided Configuration screen is displayed.
Press the [Go To NETXPORT] function key and the Network Transport Configuration Selection
screen is displayed.
For more general information on NMMGR, refer to Using
the Node Management Services (NMS) Utilities.
 |
| |
|
 | NOTE: Fields described as "HP modifiable" should
be changed only upon the recommendation of your Hewlett-Packard
representative. |
|
| |
|
Printable version
