Chapter 2 Preparing to Configure DTCs

Table of Contents

Plan the Network Configuration

Incoming PAD Security

Defining the HP 3000 System

Defining the DTC

Defining the DTC Connector Cards

Determine X.25 Connection Characteristics

Configuration Worksheets

DTC Configuration Worksheet
DTC Card Configuration Worksheet
DTC X.25 Card Configuration — Level 1 and Level 2 Worksheet
DTC X.25 Card Configuration - Level 3 & Miscellaneous Worksheet
DTC X.25 Card Configuration — System-to-System Worksheet
DTC X.25 Card Configuration - Nailed PAD Worksheet
DTC X.25 Card Configuration — PAD Security Worksheet

Configuring With NMMGR

This chapter details the information you will need before you can configure the datacommunications and terminal subsystem (DTS) for host-based systems that include X.25 networking. DTS defines the physical connections and configuration parameters for the computer, its DTCs, and all DTC-connected devices. Sample worksheets are included to facilitate configuration.

Hewlett-Packard recommends that you complete the DTS configuration before configuring any NS network capabilities for your system.

This chapter describes how to:

Plan the DTS configuration.
Determine terminal and printer characteristics.
Determine DTC characteristics.

Determine X.25 network characteristics for both PAD and system-to-system connections.




	NOTE: If you are not configuring X.25 networking capabilities on a system using host-based network management, you should use Configuring Systems for Terminals, Printers, and Other Serial Devices instead of this manual to configure DTCs and DTC connections.

Chapter 2 Preparing to Configure DTCs

Technical documentation

» Table of Contents

» Glossary

» Index