Chapter 3 Configuring DTCs Step-by-Step

Table of Contents

This chapter provides step-by-step instructions for configuring Datacommunications and Terminal Controllers (DTCs) for systems using host-based network management. If you are using this manual to configure DTCs, it is assumed that X.25 network connections will be part of the host-based configuration.

Before using NMMGR to configure DTCs, you should complete the worksheets provided. See Chapter 2 “Preparing to Configure DTCs” for more information on planning your configuration and filling out the configuration worksheets.

This chapter includes step-by-step instructions to help you perform the following tasks:

Configure host information.
Configure information for each DTC connected to the system.
Configure information for each direct connect and modem card contained in any DTC connected to the system.
Configure information for each DTC/X.25 Network Access card contained in any DTC connected to the system, including:
- X.25 level 1, 2, and 3 parameters.
- System-to-system local user group information.
- Nailed PAD connections and PAD security.
Validate your network configuration (SYSGEN cross-validation is done automatically within NMMGR).




	NOTE: If you are configuring a system that does not require X.25 system-to-system or PAD configuration, use Configuring Systems for Terminals, Printers, and Other Serial Devices instead of this manual.

Chapter 3 Configuring DTCs Step-by-Step

Technical documentation

» Table of Contents

» Glossary

» Index