From FTP, you must establish a connection to the remote host
you wish to access.
If you did not enter a remote host name on the command line
when you started FTP, you must open a connection to the remote system
as follows.
From the ftp> prompt, enter the OPEN command followed by the remote host ARPA domain name,
internet protocol (IP) address, or NS node name supplied by your
network administrator:
IP Addresses |
 |
IP addresses are assigned by your network administrator to
uniquely identify computer systems to allow communication between
systems on the network.
IP addresses, also called internet addresses, are in the form:
nnn.nnn.nnn.nnn
Where nnn is a number from 000 to 255, inclusive. For example,
if the IP address of the remote system is 123.1.20.125, you would enter:
Node Names |
|
Besides using IP addresses with the FTP OPEN command, you can use either an ARPA domain name or an
NS node name in the OPEN command. NS names are recognized if the remote host supports
the Probe protocol or if the remote host name is configured in your local
node network directory. ARPA domain names are configured in two
ASCII files, RSLVCNF.NET.SYS and HOSTS.NET.SYS. For configuration information, refer to Installing and
Managing HP ARPA File Transfer Protocol Network Manager's
Guide. Obtain the node names from your network administrator.
For example, if the name, node2, is configured as a remote host name on your network,
you can enter:
For a system identified by a fully-qualified NS nodename such
as nodex3.test.hp (in the form: nodename.domain.organization, you can enter:
Logging On |
|
Once the connection has been established, enter the remote
user logon name and password when prompted.
You must know the user logon syntax for the remote host you
are accessing. For example, an HP 9000 logon name could be: myname. You would enter the following when prompted:
Name (username) myname
331 Password required for myname.
PASSWORD: (enter password)
230 User myname logged in. |
Passwords are not echoed back to your terminal screen.
Changing Accounts |
|
To log into a different user account on the remote system,
use the USER command. After entering the user logon name, you are
prompted for any passwords associated with the logon name:
ftp> USER myname
331 Password required for myname.
PASSWORD: (enter password)
230 User myname logged in. |
Accessing Another Remote Host |
|
After establishing a connection to a remote host, you can
access another remote host by entering the CLOSE command, then entering another OPEN remotehostname command:
Printable version
