Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
A5230A & A5506B PCI 10/100Base-TX/9000 Installation Guide: HP-UX & OpenVMS Networking > Chapter 1 HP-UX Installation

Network Card Configuration Worksheet

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

Fill out one worksheet for each card you are installing.

Table 1-1 Network Card Configuration Worksheet

Data Type

Required/ Optional

Default

Where to Configure

Example

Your System

Internet address

Required

None

SAM or ifconfig

196.6.20.2

Subnet mask

Required if using subnetting

Subnet mask not used

SAM or ifconfig

255.255.248.0

Station address

Required

As shown on card

lanadmin -A or SAM

0x08000978537C

Host name alias for this network interface (card)

Required if system is connected to more than 1 network

None

SAM

abcde

Link speed

Required

None

Hub or switch*

100-MBit/s switch

*The speed configuration of the 10/100Base-TX card can be determined by the speed setting of the hub or switch port to which the card is connected. The card automatically senses this speed. The card only runs at one speed at a time. To verify the speed selection, run lanadmin and check the link speed and duplex mode at the LAN Interface Status Display.

 

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2004-2005 Hewlett-Packard Development Company, L.P.