Verifying the Installation

This section describes how to verify the SFM software installation using the TUI and the CLI.




	NOTE: The version numbers of the products shown in the figures may be different from the version you are installing.

To verify the SFM software installation, complete the following steps:

Log in to the system as a superuser.
Click Logfile in the Install window, as shown in the following figure:
The Logfile, which includes details about the installation, is displayed. If there are no errors in the Logfile, the SFM software is installed properly. If the SFM software is not installed properly, you must repeat the installation procedure.
For information about errors related to installation, enter the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile, as underlined in the Logfile window, in the following figure:
For example, enter the following command at the HP-UX prompt:
# swjob -a log iemlhamia-0013 @ iemlhamia.india.hp.com:/

To verify your installation using the CLI, complete the following steps:

Log in to the system as a superuser.
Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the SFM software is installed properly. Otherwise, you must install the SFM software again.
A sample output is shown in the following figure:
For information about installation-related errors, enter the following command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/

Technical documentation