 |
» |
|
|
|
This section describes how to use the TUI and the CLI to verify
whether the SFM software is removed successfully. Verifying
Removal Using the TUI | |
To verify whether the SFM software is removed successfully,
complete the following steps: Log in to the system as a superuser. Click Logfile in the Remove Window. If there are no errors in the Logfile, the SFM software is removed successfully. If the SFM
software is not removed properly, you must repeat the removal procedure.
See “Removing the SFM
Software” for instructions
on how to remove the SFM software. For information about errors related to the removal
of SFM, enter the following command at the HP-UX prompt: # swjob -a log <jobid> @ <system name>:/ The jobid is available in the Logfile.
Verifying
Removal Using the CLI | |
To verify if the SFM software is removed successfully, complete
the following steps: Log in to the system as a superuser. Enter the following command at the HP-UX prompt: # swjob If the output contains no errors, the SFM software is removed successfully.
If the SFM software is not removed properly, you must repeat the
removal procedure. See “Removing the SFM
Software” for instructions on how to remove the SFM software. For information about errors related to the removal
of the SFM software, enter the following command at the HP-UX prompt: # swjob -a log <jobid> @ <system name>:/ The jobid is available in the output of the swjob command.
|
Printable version
