To install the Kerberos server, complete the following steps:
Insert the software
media (tape or disk) in the appropriate drive.
Type the swinstall command at the HP-UX prompt.
For more information on the swinstall command, type man 1M swinstall at the HP-UX prompt.
In the Specify Source window, select the appropriate
path of the depot and click OK.
Highlight KerberosSvr in
the Software Selection dialog box, and select
Mark For Install from the Actions
menu to install all filesets in the bundle.
When you have marked the product
components you want to install, select Install
(analysis) from the Actions menu.
When you have successfully completed
the analysis, click OK in the Analysis
dialog to load the Kerberos server filesets.
The swinstall utility loads the filesets. The estimated time for processing
is 5 minutes.
If the installation is not successful, an error message is
displayed. The cause of the failure will appear at the end of the /var/adm/sw/swagent.log file.
For more information, see Managing
HP-UX Software with SD-UX at http://www.docs.hp.com.
Kerberos server v3.12 is ready for use.
To configure the server to act as either the primary security
server or one of the secondary security servers, see Chapter 7 “Configuring the Primary
and Secondary Security Server” for more information.
Printable version
