 |
» |
|
|
|
To verify that the system recognizes the HBA, view the
output listing from the following command: #
ioscan -fnC fc Verify the following drivers appear for each installed
adapter. If all the drivers are listed, proceed to the section titled
verifying connectivity. The ioscan -fnC fc output will display the following: # ioscan -nC fc
Class I H/W Path Driver S/W State H/W Type Description
===================================================================
fc 0 0/3/0/0/0/0 fcd CLAIMED INTERFACE HP 4Gb Dual Port PCIe Fibre Channel Mezzanine (FC Port 1)
/dev/fcd0
fc 1 0/3/0/0/0/1 fcd CLAIMED INTERFACE HP 4Gb Dual Port PCIe Fibre Channel Mezzanine (FC Port 2)
/dev/fcd1
fc 2 0/4/0/0/0/0 fcd CLAIMED INTERFACE HP 8Gb Dual Port PCIe Fibre Channel Mezzanine (FC Port 1)
/dev/fcd2
fc 3 0/4/0/0/0/1 fcd CLAIMED INTERFACE HP 8Gb Dual Port PCIe Fibre Channel Mezzanine (FC Port 2)
/dev/fcd3
|
The third column represents the hardware path of the slot that
the adapter is installed. This path will be different for each installed
adapter port. Observe whether the ioscan output reports
the following: fc 0/4/0/0/0/1 UNCLAIMED UNKNOWN |
If reported, HP-UX detected the adapter but the fcd driver is not recognized. If the correct driver is installed and the adapter is
not listed in the ioscan output, contact HP for
assistance.
|
Printable version
