 |
» |
|
|
|
To verify that the system recognizes the HBA, view the
output listing from the following command: #
ioscan -fnC fc Verify the following drivers appear for each installed
adapter. If all the drivers are listed, proceed to the section titled
verifying connectivity. The ioscan -fnC fc output will display the following: Class I H/W Path Driver S/W State H/W Type Description
====================================================================
fc 0 0/3/0/0/0/0 fclp CLAIMED INTERFACE HP 403621-B21 4Gb PCIe 2-port LPe1105 FC Mezzanine Adapter
/dev/fclp0
fc 1 0/3/0/0/0/1 fclp CLAIMED INTERFACE HP 403621-B21 4Gb PCIe 2-port LPe1105 FC Mezzanine Adapter
/dev/fclp1
fc 2 0/4/0/0/0/0 fclp CLAIMED INTERFACE HP 456972-B21 8Gb PCIe 2-port LPe1205 FC Mezzanine Adapter
/dev/fclp2
fc 3 0/4/0/0/0/1 fclp CLAIMED INTERFACE HP 456972-B21 8Gb PCIe 2-port LPe1205 FC Mezzanine Adapter
/dev/fclp3 |
The third column represents the hardware path of the slot that
the adapter is installed. This path will be different for each installed
adapter port. Observe whether the ioscan output reports
the following: fc 0/4/0/0/0/1 UNCLAIMED UNKNOWN |
If reported, HP-UX detected the adapter but the fclp driver is not recognized. If the correct driver is installed and the adapter is
not listed in the ioscan output, contact HP for
assistance.
|
Printable version
