This note applies only if the hardware configuration
contains HP ProLiant DL140 G2 or DL145 G2 nodes and you are upgrading
an existing HP XC system from Version 2.1 or Version 3.0 to Version 3.1.
The HP ProLiant DL140 Generation 2 (G2) and DL145
G2 series of hardware models must be installed with BMC firmware version
1.25 or greater. However, the BMC version 1.25 firmware was not supported
by HP XC Version 3.0 or earlier. As a result, you must update the
BMC firmware on these nodes after you upgrade the system to HP XC Version 3.1, which is contrary
to the upgrade instructions for a typical upgrade.
Before upgrading an HP XC system to Version 3.1,
contact the HP XC Support Team and request the procedure to upgrade
the BMC firmware on HP ProLiant DL140 G2 and DL145 G2 nodes:
<xc_support@hp.com>
Printable version
