Use this section only if you need to add or modify the system
parameter information described in “Getting Required Information”. Any
modifications should be made as soon as possible after initial
installation.
Log in as the superuser and type the following command in a
terminal window:
/sbin/set_parms option Enter
|
Where option is one of the following:
- Option ...
Modifies or sets ...
- hostname
System host name
- timezone
Time zone
- ip_address
Internet Protocol address
- addl_netwrk
Additional network parameters (see page 1-7)
- font_c-s
Network font service (see page 1-7)
You can also set network parameters or network font service using the icons
labeled SetNetworking and FontClientSrvr, located in the
General Toolbox in the System_Admin subdirectory (see “Creating a New User Account” for instructions on opening the toolbox).
Any changes you make in set_parms will take effect after
rebooting the system.
You can also use SAM to add or change most of this information.
Printable version
