rp54xx
Servers support up to four optional internal hard drives. These
drives must be installed in the following sequence:
It is not necessary to shutdown the HP-UX operating system
or power off the server to install a new disk. Follow this procedure
to add internal hard disk drives to your rp54xx Server.
If a front bezel is installed on the face
of the server, open the right-hand panel to gain access to the disk
slots.
Remove the disk drive slot cover.
Insert the new disk drive into the slot until the rear
connectors snap into place in the card guide. As shown in the following
graphic, the notches at the top of the disk drives must snap over
the small brackets in the disk bay to ensure a firm connection.
Secure the connection by pushing the blue release lever
closed.
Refer to HP-UX documentation to configure the new disk.
Printable version
