Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
Installation Guide rp5400 Family of Servers > Chapter 2 Server Unpacking and Installation

Install Deskside Server

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

The following section describes the installation of a server into a Deskside enclosure for installation in an office environment.

WARNING! The typical rp54xx system can weigh up to 68kg (150lbs). HP recommends using an approved lifting device.
  • Lift and move the server in accordance with all local safety regulations.

  • Do not attempt to lift the server by the plastic handles on the top and side covers.

    Failure to follow these precautions can cause injury to personnel or damage to equipment.

  1. Unpack the server.

  2. Unpack the deskside enclosure.

    NOTE: Ensure that the positioning spring pins in the enclosure base align with the alignment holes in the bottom of the server.
  3. Position the server on the wheeled enclosure base.

  4. Tighten the two captive screws in the enclosure base to secure the server to the base.

  5. Position the enclosure cover (outside skin) over the server and install and tighten the screws to secure it to the base.

    NOTE: The perforations and the lip of the outside skin should be toward the rear of the server.
    WARNING! Stacking rp54xx Servers in deskside enclosures is not supported.

    Stacking rp54xx Servers in deskside enclosures can damage equipment, may cause injury to personnel, and may void your warranty or service contract.

  6. Install the Front Bezel.

  7. Locate the two pull-tabs. One pull-tab is longer than the other. The shorter pull-tab is blank on both sides. The back of the shorter pull-tab provides a writable surface for twin use.

  8. Locate the plastic bag containing the label sheet (taped to the server).

  9. Remove the label containing serial number, base product, processor product, and model information from the label sheet and apply to the back of the longer pull-tab.

    NOTE: Pull-tab and label shown above is for an rp74xx Server. rp54xx uses the same style label and similar pull-tab.
  10. Insert the pull-tabs into the front bezel. Install the longer pull-tab in the left side plastic window in such a way that the rp54xx logo is visible. Install the shorter pull-tab in the right side plastic window with either surface visible. Refer to the diagram above for pull-tab locations.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2002-2004 Hewlett-Packard Development Company, L.P.