The
following section describes installation of the HP Secure Web Console
on inside of the rear door of a rack-mounted rp54xx Server.
For technical, installation, and configuration instructions
for the Secure Web Console, refer to the following URLs on the Internet:
General information: http://www.hp.com/
Documentation: http://www.docs.hp.com
 |
| |
|
 | NOTE: Either the system console (HP series 700 terminal) or
the HP Secure Web Console may be installed on an rp54xx Server,
but not at the same time. Both console types use the same DB9 type
LAN Console connector. |
|
| |
|
To install the HP Secure Web Console on an rp54xx Server,
refer to the previous figure and the HP Secure Web Console documentation,
then proceed as follows:
Install the wire mounting bracket by carefully
inserting the two top prongs through the vent grill in the rear
door of the cabinet as shown above. Position the bracket toward
the hinge side of the door.
Place the Secure Web Console power supply into the bottom
portion of the wire mounting bracket as shown.
Connect one end of the power cable to the power supply
where indicated.
Position the Secure Web Console unit in the mounting
bracket.
Connect the DC out cable from the power supply to the
Secure Web Console.
Connect one end of the AC power cord (supplied) to the
Secure Web Console power supply.
Connect the other end of the AC power cord to an available
receptacle.
On a PDU if in a cabinet.
In an available wall outlet if in a Deskside enclosure.
Connect the 9-pin end of the RS-232 cable (Supplied)
to the connector labeled CONSOLE on the A5591-63002 “W-type” adapter
cable.
|
| |
|
 | CAUTION: To prevent unauthorized access to your rp54xx system,
do not connect the other end of the serial cable to the Secure Web
Console until both the server and the Web Console have both been
fully configured. |
|
| |
|
Connect one end of a LAN cable to RJ-45 connector labeled
10-Base-T on the Secure Web Console.
Connect the other end of the same LAN cable to your
site LAN.
Configure the Secure Web Console in accordance with
the documentation that was provided with it or refer to http://www.docs.hp.com
Once the Web Console has been properly configured, the
remaining end of the serial cable between the server and the Web
Console may be connected.
Printable version
