Performing a Visual Inspection and Completing the Installation

After booting the system, carefully inspect it and reinstall the EMI covers. Here are the steps required to perform a final inspection and complete the installation:

Visually inspect the system to verify that all components are in place and secure.
Check that the cables are secured and routed properly.
Check that the cell board ejectors are secure.
If the ejectors are broken or open, the cell board is disconnected.
Figure 2-54 Cell Board Ejectors7
Reinstall the front EMI panel.
1. Hook the flange at the lower corners of the EMI panel into the holes on the cabinet.
  Figure 2-55 Front EMI Panel Flange and cabinet Holes
2. Position the panel at the top lip and lift the panel up while pushing the bottom into position.
  The EMI gasket may have to be compressed to get the panel to seat properly.
3. Reattach the screw at the top of the EMI panel.
  Figure 2-56 Attaching Front EMI Panel
Check that the cables inside the rear enclosure are secure.
Reinstall the back EMI panel.
1. Align the lip inside the cabinet with the lip on the EMI Panel.
  Figure 2-57 Reinstalling the Back EMI Panel
2. Push the EMI panel up and in. The EMI gasket may have to be compressed at the top of the enclosure to get the panel to seat properly.
3. Reattach the screw at the bottom of the EMI panel.

Performing a Visual Inspection and Completing the Installation

Technical documentation

» Table of Contents

» Index