Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 User Guide hp Integrity Superdomehp 9000 Superdome > Chapter 3 Removing and Replacing Components

Removing and Replacing the Rear Electromagnetic Interference (EMI) Cover
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

There is an EMI (Electromagnetic Interference) cover on the rear of the cabinet. This cover is secured with one captive screw in the lower center of the cover. The screw can be seen through the hole in the lower center of the cover. Care should be taken so as not to damage the EMI gasket on the cover. This cover is easily removed.

Figure 3-3 Rear EMI Cover Location

Rear EMI Cover Location

Removing the Rear EMI Cover

  1. Open the rear cabinet door.

  2. Loosen the single slotted T-25 captive screw in the lower center of the EMI cover.

  3. Using the handle on the EMI panel, tilt the cover away from the chassis at the captive screw edge.

  4. Remove the cover from the chassis.

Figure 3-4 Rear EMI Cover Detail

Rear EMI Cover Detail

Replacing the Rear EMI Cover

The rear cover is held in place at the top by a channel in the cover that slides into a lip on the chassis.

  1. Push the top of the cover into the lip and rotate the cover into position flush with the chassis frame.

  2. Tighten the single captive screw in the lower center of the EMI cover.

  3. Close the rear cabinet door.

CAUTION: Take care not to damage the EMI gasket on the cover.

Figure 3-5 Rear EMI Cover Installation

Rear EMI Cover Installation


Removing and Replacing the Front Electromagnetic Interference (EMI) Cover
  		 


Removing and Replacing the Side EMI Covers (for a two cabinet system)  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© Hewlett-Packard Development Company, L.P.