Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 User Guide hp Integrity Superdomehp 9000 Superdome > Chapter 3 Removing and Replacing Components

Removing and Replacing the Bulk Power Supply (BPS)
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

The Bulk Power Supply (BPS) is located in the front end power system (FEPS). The BPS is an N+1 component and is easily replaced.

Removing the Bulk Power Supply

This section contains information on removing a BPS.

Figure 3-6 BPS detail

BPS detail

  1. Loosen the single captive thumbscrew in the lower front center portion of the BPS.

  2. Slide the power supply forward using the handle to remove it from the FEPS.

  3. Make note that the BPS is defective for future reference.

Replacing the Bulk Power Supply

  1. Grip the handle with one hand while supporting the rear of the BPS in the other hand and insert the BPS into the same slot from which it was removed.

  2. The BPS easily slides into the FEPS; however, use a slow firm pressure to properly seat the connection.

  3. Tighten the single captive thumbscrew in the lower center of the BPS.

NOTE: Do not over tighten the captive thumbscrew.


Removing and Replacing the Side EMI Covers (for a two cabinet system)
  		 


Installing An Additional Power Distribution Control Assembly  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© Hewlett-Packard Development Company, L.P.