|
|
United States-English | |
|
|
 |
|
HP 9000 and HP Integrity Systems: AB290A PCI-X 2-Port U320 SCSI and 2-Port Gigabit Ethernet Combination Card Installation Guide
Chapter 1 Hardware and Software Installation Procedure |
|
|
Table of Contents
These instructions apply to AB290A PCI-X 2-Port U320 SCSI and 2-Port Gigabit Ethernet combination cards. For pre-requisite information such as system firmware requirements or card firmware requirements, please see the AB290A Combination Card Support Matrix on the web at http://docs.hp.com under “I/O Cards and Networking Software” and then under “Combination Cards.” If your combination card was factory installed (ordered on product option 0D1), the two software bundles required for this card --IEther-00 (for LAN) and scsiU320-00 (for SCSI) are already loaded onto your system’s hard drive.[1] Adding in the card: HP-UX 11i v 1.0 If your system is HP-UX 11i v 1.0 based, you need to get the two driver bundles from the December 2004 version of HP-UX 11i v 1.0. You do not necessarily have to load the entire OE if you don’t want to. To add the product for 11i v 1.0:
Adding in the card: HP-UX 11i v 2.0 of September 2004 or later
These AB290A combination cards can be added to your system or replaced without the need to shut down or reboot the system--a process called online addition and replacement (OLAR). The following instructions assume you are not performing online addition and replacement. [1] If your combination card was factory installed (ordered on product option 0D1), you do not need to perform the hardware and software installation steps,. You still need to configure the card’s IP address and possibly set other parameters and options such as those mentioned in Table 1-2 “Network Configuration Worksheet” The Network Configuration worksheet. |
|||||||||||||||||||||||||||||||||||||||||||||||||||
 Printable version |
|
|
|
|
|
|||||||||||||||
|
|||||||||||||||
