|
|
United States-English | |
|
|
 |
|
HP 9000 and HP Integrity Systems: AB545A PCI-X 4-Port Gigabit Ethernet Card Installation Guide
Chapter 1 Hardware and Software Installation Procedure |
|
|
Table of Contents
These instructions apply to AB545A PCI-X 4-Port Gigabit Ethernet cards. If your LAN card was factory installed (ordered on product option 0D1), the software bundle required for this card -- IEther-00 is already loaded onto your system’s hard drive.[1] Adding in the card: HP-UX 11i v 1.0 If your system is HP-UX 11i v 1.0 based, you can get the software bundle from the December 2004 (or later) version of HP-UX 11i v 1.0 on the OE and/or Application Software media. You do not necessarily have to load the entire operating environment (OE) if you don’t want to. To add the product for 11i v 1.0:
Adding in the card: HP-UX 11i v 2.0 of September 2004 (or later)
These AB545A cards can be added to specified systems or replaced without the need to shut down or reboot the system--a process called online addition and replacement (OLAR). If performing OLAR, patches are required -- see “Product Overview”. The following instructions assume you are not performing online addition and replacement. [1] If your LAN card was factory installed (ordered on product option 0D1), you do not need to perform the hardware and software installation steps,. You still need to configure the card’s IP address and possibly set other parameters and options such as those mentioned in Table 1-2 “Network Card Configuration Worksheet” The Network Card Configuration worksheet. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||
 Printable version |
|
|
|
|
|
|||||||||||||||
|
|||||||||||||||
