 |
» |
|
|
|
Follow the steps below to prepare the system for installation
of your network interface hardware. At the HP-UX prompt, execute the command: Wait for the system to respond with a message indicating that
the system has been halted. Observe antistatic precautions by following the
guidelines as described in the installation instructions in the
hardware manual or the Antistatic Precautions Note. Install your network interface
card by referring to your hardware installation and service manual. | | | |  | CAUTION: HP recommends not rearranging any network interface
cards installed in your system. If you move any existing network
interface card in the system, you may need to reconfigure the IP
address. See "Reconfiguring IP Addresses" section
in the next chapter. | | | | |
Power up the system to complete the process. The network
interface card will run a self-test automatically. Any error messages
will appear on the terminal display or system console. Proceed to chapter 2, "Configuring LAN/9000
Using SAM."
|
Printable version
