HP-UX Manual Reference Pages

arp(1M) displays and modifies the Internet-to-Ethernet and Internet-to-Fibre Channel address translation tables used by the Address Resolution Protocol.

eisa_config(1M)interprets information stored in configuration files and uses it to configure system resources needed to properly interact with EISA cards on HP 9000 EISA systems.

hosts(4) contains database that contains a single line entry for each host name entry.

ifalias(1M) configures network interface to support multiple IP addresses at Network Layer.

ifconfig(1M) assigns an address to a network interface and configures parameters, such as the netmask, broadcast address, and trailer support.

ioscan(1M) scans system hardware, usable I/O system devices, or kernel I/O system data structures as appropriate, and lists the results.

lanadmin(1M) resets or reports status of the LAN card.

lanconfig(1M) configures network interface parameters at Data-Link Layer.

lanscan(1M) displays information about LAN adapters that are successfully bound to the system.

linkloop(1M) verifies network connectivity through the Data Link Layer.

ndd(1M) displays and modifies network driver parameters.

netfmt(1M) formats the nettl tracing and logging binary files.

netstat(1M) provides network statistics and information about network connections.

nettladm(1M) captures and controls network tracing and logging information.

nettl(1M) controls network tracing and logging.

ping (1M) verifies network connectivity through the Network Layer and reports round-trip time of communications between the local and remote hosts.

route(1M) adds and deletes entries to the network routing table, allowing your system to communicate through a gateway.

swinstall(1M) loads software filesets onto 10.0 systems.

traceroute(1M) traces the network path between two points at Network Layer.