 |
» |
|
|
|
Follow the steps below to
prepare the system for installation of your network interface hardware. At the HP-UX prompt, execute the command: Wait for
the system to respond with a message indicating that the system
has been halted. Observe antistatic precautions by following the
guidelines as described in the installation instructions in the
hardware manual or the Antistatic Precautions Note. Install your network interface
card by referring to your hardware installation and service manual. | | | |  | CAUTION: HP recommends not rearranging any network interface
cards installed in your system. If you move any existing network
interface card in the system, you may need to reconfigure the IP
address. See “Reconfiguring IP Addresses” section
in the next chapter. | | | | |
Power up the system to complete the process. The
network interface card will run a self-test automatically. Any error
messages will appear on the terminal display or system console. Proceed to chapter 2, “Configuring HP-UX
LAN Using SAM.”
|
Printable version
