Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 HP 9000 Networking: Using PCI 10/100Base-TX/9000 > Chapter 1  Installing and Configuring PCI 10/100Base-TX/9000

Compatibility and Installation Requirements
» 

Technical documentation

» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

Following are the limits of the current PCI 10/100Base-TX/9000:

  • The PCI 10/100Base-TX/9000 LAN software is for use with only the following protocols: TCP/IP, ARPA, and NFS.

  • Both full and half-duplex modes are supported. Ensure that your hub or switch is set to the desired duplex mode.

  • When using the ioscan -f command to verify installation, the last digit of the H/W Path (hardware path) will show the port number of the card. The other fields of the output will show the driver as btlan5, and the Hardware Type Description will be PCI (10110009)--builtin #1.



Introduction
  		 


Required and Optional Patches  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© Hewlett-Packard Development Company, L.P.