Installation Step: CCmon installation |
|
After SGeSAP has been successfully installed and configured,
it is possible to install the Cluster Consistency Monitor as well.
There is a setup tool available with CCmon. It has to be called
as follows:
# cd /opt/cmcluster/sap/ccmon
# ./Setup_Ccmon -v
 |
# Setup_CCmon: Installation Tool for the Cluster Consistency Monitor
# Node : hpcc006
# Time : Fri Dec 7 10:06:11 2001
# Version : 1.00 (32 Bit), compiled at 15. November 2001 for HP-UX 11.00
# Build : 20
# Author : SAP/HP Competence Center, Walldorf, Germany
10:06 Setup_CCmon(): Execute: "/usr/bin/tar -xf /opt/cmcluster/sap/ccmon/ccmon.tar"
10:06 Setup_CCmon(): Found O/S Version "B.11.11"
10:06 Setup_CCmon(): Execute: "/usr/bin/tar -xf /opt/cmcluster/sap/ccmon/ccmon.tar"
10:06 Setup_CCmon(): Found 64 Bit enabled in the O/S
You may now configure the following Profiles:
-> /opt/cctool/etc/profile/SCAN_RSDB.pfl
-> /opt/cctool/etc/profile/COMP_MCSG.pfl
-> /opt/cctool/bin/CheckMCSG
-> Configure your Alarm Handlers
-> Copy the Configuration to other Clusternodes
-> Insert an Entry into the crontab of each Node
*** More Information on this Configuration Steps is in the Installation
*** Guide /opt/cctool/doc/CCmon_Handbook.doc (Microsoft Word Format)
*** Normal End of Programm, Bye ...
|
|
After this step has been finished, you will find more information
about how to configure and execute the CCMon in the manual located
at: /opt/cctool/doc/CCmon_Handbook.doc.
For a temporary (10 Days valid) or a final Installation, it
is required to install a license. Please contact your HP representitive
to generate this license for your installation. For the license
generation a hardware key of the system you are running CCmon is
required. Generate the key on each node you want to run CCmon.
The following command generates the hardware key: /opt/cctool/bin/licgen -get.
>Node-Key: 1705415577
Send this key to your HP representative and you will obtain
a license key to install.
Printable version
