Instant Capacity Software Validation

On HP-UX Systems

The Instant Capacity software (HP-UX product B9073BA) is installed by HP manufacturing on instantly ignited HP-UX systems. The Instant Capacity software can also be installed by an HP service representative on existing (supported) HP-UX enterprise servers as an add-on.

	NOTE: The Instant Capacity software is automatically installed when the HP-UX 11i v3, 11i v2, or 11i v1 Operating Environment (OE) is installed.

To verify the Instant Capacity software is installed on your system, execute the following HP-UX command:

/usr/sbin/swlist -l product iCOD

You should see output similar to:

iCOD   B.11.23.08.03   HP-UX iCOD Instant Capacity

To ensure the Instant Capacity software installation has not been corrupted, execute the following HP-UX command:

/usr/sbin/swverify iCOD

You should see Verification succeeded. in the output of the swverify command.

On OpenVMS Systems

On OpenVMS systems, the Instant Capacity software is automatically installed on partitionable systems when the OpenVMS V8.3 or later operating system is installed. You should not need to install iCAP software separately on OpenVMS systems. On-site iCAP installation by an HP service representative after the initial installation of OpenVMS 8.3 is not an option for OpenVMS systems.

On OpenVMS systems, run the following commands to verify the Instant Capacity software is installed and configured:

$ @sys$manager:ICAP$CLI_UTILS.COM CONFIG_CHECK
$ show log ICAP$CONFIGURED
"ICAP$CONFIGURED" = "TRUE" (LNM$JOB_nnnnnnnn)