Introduction

This document contains information about last-minute changes to HP-UX 11i Version 1.5 and to the cold-install procedures.

Read this document in its entirety before reading any other 11i Version 1.5 documentation, and before taking any steps to install HP-UX 11i Version 1.5.

HP-UX 11i Version 1.5 is the first release for all IPF (Itanium processor family)-based HP-UX systems.
The release ID for HP-UX 11i Version 1.5 is B.11.20, and the term HP-UX 11i Version 1.5 (B.11.20) is used throughout the Release Notes and the Installation and Configuration Guide. “Media Kit Contents” and “Additional Information” for information about these documents.




	NOTE: Beginning with HP-UX 11i, the operating system is delivered as part of the HP-UX Operating Environment (OE). An Operating Environment is an integrated and tested software solution containing the operating system and selected applications. In this release, the operating system and selected applications are provided on two DVDs, to install the full OE, you must install from both DVDs.

PA-RISC based systems should continue to run HP-UX 11i (release ID B.11.11) or earlier releases. This release will not run on PA-RISC based systems; however, any PA-RISC binaries you have most likely will run on IPF systems. See http://devresource.hp.com for more information.

Introduction

Technical documentation

» Table of Contents

» Index