Step 2: Loading 100VG-AnyLAN Software

Log in as root

Insert the software media (tape or disk) into the appropriate drive.

Run the swinstall program using the command:

swinstall

This opens the Software Selection Window and Specify Source Window of the swinstall program.

Change the Source Host Name, if necessary, enter the mount point of the drive in the Source Depot Path field, and activate the OK button to return to the Software Selection Window. Activate the Help button to get more information.

The Software Selection Window now contains a list of available software bundles to install.

Highlight the 100VG-AnyLAN/9000 software for your system type.

Choose Mark for Install from the ''Actions'' menu to choose the product name(s) is to be installed.

Choose Install from the ''Actions'' menu to begin product installation and open the Install Analysis Window.

Activate the OK button in the Install Analysis Window when the Status field displays a Ready message.

Activate the Yes button at the Confirmation Window to confirm that you want to install the software. swinstall displays the Install Window.

View the Install Window to read processing data while the software is being installed. When the Status field indicates Ready and the Note Window opens. swinstall loads the fileset, runs the control scripts for the fileset, and builds the kernel. Estimated time for processing: 3 to 5 minutes.

Activate the OK button on the Note Window to reboot the system.

The user interface disappears and the system reboots.

When the system reboots, check that the swinstall log file in tail /var/adm/sw/swagent.log to make sure the installation was successful. Use the tail command to locate the 100VG software.