Log in as root
Insert the software media (tape or disk) into the
appropriate drive.
Run the swinstall program using
the command:
This opens the Software Selection Window and Specify Source
Window of the swinstall program.
Change the Source Host Name, if necessary, enter
the mount point of the drive in the Source Depot Path field, and
activate the OK button to return to the Software
Selection Window. Activate the Help button to get more information.
The Software Selection Window now contains a list of available
software bundles to install.
Highlight the NetWare 4.1 software for your system
type.
Choose Mark for Install
from the ''Actions'' menu to
choose the product name(s) to be installed.
Choose Install
from the ''Actions'' menu to
begin product installation and open the Install Analysis Window.
Activate the OK button in
the Install Analysis Window when the Status field displays a Ready
message.
Activate the Yes button at
the Confirmation Window to confirm that you want to install the
software, swinstall displays the Install Window.
View the Install Window to read processing data while the
software is being installed. When the Status field indicates Ready
and the Note Window opens. swinstall loads
the fileset, runs the control scripts for the fileset, and builds
the kernel. Estimated time for processing: 3 to 5 minutes.
Activate the OK button on
the Note Window to reboot the system.
The user interface disappears and the system reboots.
When the system reboots, check the swinstall
log file in /var/adm/sw/swagent.log when the
system reboots using the tail <filename> command to make
sure the installation was successful. Use the tail
command to locate the NetWare 4.1 software.
Go to the next section, "Step 3: Install
License Codeword."
Printable version
