Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 HP Auto Port Aggregation Administrator's Guide: HP-UX 11.0, 11i v1, 11i v2 > Chapter 2 Installing the APA Software

Installation Requirements
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

  1. Log in to the HP-UX server as superuser.

  2. Confirm that the /usr/bin, /usr/sbin, and /sbin directories are in your PATH by using the echo $PATH command.

  3. Use the uname -a command to determine the HP-UX version of your system.

  4. Install the required patches for your system as described in the “Required Patches” section of the release notes.

Hardware Requirements

Supported Switches

HP APA supports the Cisco FastEtherChannel (PAgP) protocol, the Link Aggregation Control Protocol (LACP) (IEEE 802.3ad), and manual trunking mechanisms. HP has tested switches from the following vendors to work with HP APA:

  • 3Com

  • Cisco

  • HP Procurve

  • Foundry

  • Alteon

  • Nortel

  • Extreme

With the September 2007 release of HP APA for HP-UX 11i v1 and HP-UX 11i v2 (B.11.11.30 and B.11.23.30, respectively), HP APA also supports Nortel's Split Multi-Link Trunking (SMLT) technology. Specifically, HP has tested the Passport 8006 and Passport 8010 switches with the version 3.7.13.0 of the software.

Supported LAN Cards

The following network interface cards are supported for HP-UX 11.0 and 11i v1:

  • All HP HP-PB, HSC, and PCI 10/100Base cards (both FX and TX)

  • All HP HSC and PCI 1000Base cards (both Base-T and SX)

  • HP-PB and PCI Token Ring (failover groups only)

  • HP-PB and PCI FDDI (failover groups only)

The following network interface cards are supported for HP-UX 11i v2:

  • All HP PCI 10/100Base cards (both FX and TX)

    NOTE: HP APA does not support the 10/100 BT Standard/Management LAN interface found on some systems and controlled by the intl100 driver, and any other devices controlled by the intl100 driver.

  • All HP PCI 1000Base cards (both Base-T and SX)

  • PCI-X 10 GbE Fiber cards (failover groups only)

  • All HP PCI-X 2-port Combination cards (network ports only)

  • PCI Token Ring (failover groups only)

  • PCI FDDI (failover groups only)

Operating System Requirements

HP-UX 11.0, 11i v1, or 11i v2.

Software Requirements

For the December 2005 release of HP APA for HP-UX 11i v2 (B.11.23.10) and later releases, if you want to use 8 ports for trunking HP APA requires the following software:

  • Transport Optional Upgrade (TOUR) 3.0

  • Streams Advance Release (STAR) 1.0

  • IPFilter version A.03.05.12, if you use IP Filter



Chapter 2 Installing the APA Software
  		 


Installing the Software  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2007 Hewlett-Packard Development Company, L.P.