Verifying the Configuration

To verify which link aggregates have been configured, enter either of the following commands:

# lanscan

# lanscan -v

The Hardware Path column contains the link aggregates. Link aggregate names begin with LinkAgg. The Hdw State column shows the link aggregate state. UP indicates the link aggregate is operational. DOWN indicates the link aggregate was initialized but not configured.

To verify that a link aggregate was formed correctly, use the link aggregate PPA from the Crd In# column preceding step and enter the following command:

# lanadmin -x -i linkAggPPA

For example, to verify the physical ports associated with link aggregate 901, enter:

# lanadmin -x -i 901

To verify all physical ports in all configured link aggregates, enter:

# lanscan -q

This command lists the card instance number for each physical port and for the link aggregates. Output similar to the following is displayed:

900           5 6 8 7
901
902
903

The preceding example shows that link aggregate 900 contains four ports: lan5, lan6, lan8, and lan7.