Check that the operating system has all of the following patches:
For HP-UX 11.0:
XSWGR1100, General Release Patch
PHNE_25423 or greater, Transport Patch
This patch is dependent on the following patches:
PHKL_22840
PHKL_24943
PHNE_22566
Depending on your OS version, you may need to install these patches
before installing patch PHNE_25423 or greater. Check the patch documentation
for more details.
For HP-UX 11.i
PHNE_24211, Transport Patch
For IPv6 use with IPSec/9000:
To use IPSec/9000 over IPv6, you must
install the HP-UX 11i IPv6 ™product.
Check the latest IPSec/9000 release note for additional patch information.
To obtain information about the OS, execute the command:
uname -a
To obtain information about a patch, execute the command:
swlist -i
Check that you have filled out the appropriate IPSec/9000 Configuration
worksheets at the end of this chapter. Additional information on
configuration parameters can be found in the on-line Help of the
IPSec/9000 Manager GUI.
You have root access and are designated the network
security administrator.
You have access to a graphical display, either on
your system, a remote HP-UX workstation or a remote display device.
If you are using RSA signature for ISAKMP
authentication, ensure that you are registered and can communicate
with a certificate authority.
For a VeriSign CA, you must set up a VeriSign ON-SITE account.
For information on how to do this, contact VeriSign at www.verisign.com. Also,
see "Step 5B: Setting Up a VeriSign Administrator."
For an Entrust CA, see "Step 5A: Prerequisites for
Using Entrust Certificates."
NOTE: VirtualVault
If you are installing IPSec/9000 with VirtualVault (HP-UX
11.04), check that the following patches have been installed
Printable version
