Step 2: Loading the HP-UX IPSec Software

Log in as root.

Insert the HP-UX IPSec disk into the appropriate drive, or locate the directory into which you downloaded the software from HP Software Depot.

Run the swinstall program using the command:

swinstall

This opens the Software Selection window and the Specify Source window.

If you need additional information about the Specify Source window, click the Help button on the window.

On the Specify Source window, change the Source Host Name if necessary.

Enter the mount point of the drive in the Source Depot Path field and click OK to return to the Software Selection window.

The Software Selection window now contains a list of available software bundles to install.

Highlight the HP-UX IPSec software for your system type.

Choose Mark for Install from the Actions menu to choose the product to be installed. With the exception of the manpages and user’s manual, you must install the complete IPSec product.

Choose Install from the Actions menu to begin product installation and open the Install Analysis window.

Click OK in the Install Analysis window when the Status field displays a Ready message.

Click Yes in the Confirmation window to confirm that you want to install the software. swinstall displays the Install window.

Read processing data while the software is being installed. When the Status field indicates Ready, the Note window opens.

swinstall loads the fileset, runs the control scripts for the fileset, and builds the kernel. Estimated time for processing: 3 to 5 minutes.

Click OK on the Note window to reboot the system.

The user interface disappears and the system reboots.

When the system reboots, check the log files in /var/adm/sw/swinstall.log and /var/adm/sw/swagent.log to make sure the installation was successful.

	NOTE: Do not run the HP-UX IPSec product when the system is booted in single-user mode.