Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 HP A5856A RAID 4Si PCI 4-Channel Ultra2 SCSI Controller: Installation and Administration Guide > Chapter 2 Installing the HP RAID 4Si Product

Labeling the Cables
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

Because of the way RAID writes your data in stripes, some of the data could be corrupted if the cables connecting the controllers and JBODs were switched somehow. So, we recommend that you put a label on each cable that shows the following information:

  • The controller's slot number (this is stenciled on the system).

  • The controller's port letter (and corresponding number: A=0, B=1, C=2, and D=3).

  • The JBOD's BCC location (top or bottom) and its port letter (A or B).

After you have labeled all of the cables, go to the next section, “Verifying the Installation”.



Connecting the Disks
  		 


Verifying the Installation  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2002, - Hewlett-Packard Development Company, L.P.