 |
» |
|
|
|
Boot your hard partition using the
Ignite-UX server. If your Ignite server's IP address is
15.xx.yy.zz: BCH> bo lan.15.xx.yy.zz install
Interact with IPL: n Using the Ignite-UX server, install HP-UX, desired
patches, the Quality Pack bundle, the vPars bundle, and the desired vPars-related
bundles onto the disk that will be the boot disk of the first virtual
partition. NOTE: So that the TERM variable will
always be set correctly, you should ensure that the first virtual
partition owns the hardware console port. For more information,
see “Ensuring
the Hardware Console Port Is Owned by the First Virtual Partition”. Use ioscan to verify the hardware addresses in your virtual partition
plan. # ioscan Create the virtual partitions using the information
you prepared in the virtual partition plan. For the example hard partition, the commands are: # vparcreate -p winona1 -a cpu::2 -a cpu:::2 -a mem::640 -a io:0.0 -a io:0.4 -a io:0.0.2.0.6.0:BOOT
# vparcreate -p winona2 -a cpu::2 -a cpu:::2 -a cpu:41 -a cpu:45 -a mem::1280 -a io:0.8 -a io:1.10 -a io:0.8.0.0.5.0:BOOT
# vparcreate -p winona3 -a cpu::1 -a cpu:::1 -a mem::1280 -a io:0.5 -a io:1.4 -a io:1.4.0.0.5.0:BOOT
Reboot the hard partition. # shutdown -r Interrupt the boot process as your hard partition
comes back up to reach the ISL prompt. BCH> bo pri
interact with IPL: y At the ISL prompt, boot the monitor and the initial
virtual partition. In our example, the command is: ISL> hpux /stand/vpmon vparload -p winona1 From the console of the running virtual partition
(in this example, the running virtual partition is winona1),
if the TERM environment variable is set
to unknown, change the TERM environment
variable to hpterm. For example, in the
POSIX shell the command is: # export TERM=hpterm Continuing on the console of the running virtual
partition (winona1), perform the following for each remaining virtual
partition: boot the
target virtual partition from the running virtual partition using vparboot. The syntax is: # vparboot -p <target_partition>
-I <IP_of_ignite_server>,/opt/ignite/boot/WINSTALL For our example, if the target partition is winona2,
we would execute the following command from winona1: # vparboot -p winona2
-I 15.xx.yy.zz,/opt/ignite/boot/WINSTALL You will see messages similar to the following: Sending /var/tmp/VPAAAa08035 to monitor (15786 Kbytes)...
Sending
/var/tmp/VPFSBAAa08035 to monitor (8960 Kbytes)...
# <MON> winona2
loaded press Ctrl-A until you
see the console of the target partition. The console will display
the Ignite-UX installation interface. enter the boot disk path,
lan info, hostname, and IP of the target partition into the Ignite-UX
interface and install HP-UX, desired patches, the Quality Pack bundle,
the vPars bundle, and the desired vPars-related bundles. As a result
of this process, the virtual partition will automatically reboot. | | | |  | TIP: If you get a garbled display, you can press Ctrl-L to
refresh the display. | | | | |
Your hard partition should now be booted with all virtual
partitions up. |
Printable version
