 |
» |
|
|
|
Read the ACC software from the installation media, in superuser
mode, using the swinstall utility. | | | |  | CAUTION: You must consult the Release Notes with this product
for important details, particularly about required HP-UX patches.
Install them before proceeding. | | | | |
Log in to the system as “root”. Place the media in a local or remote CD-ROM drive. Run swinstall,
which behaves the same in the GUI interface as for the terminal
interface. When the "“Specify Source”" box
opens, select "“Source Depot Type”" to “Local
CDROM”, or for a remote CD-ROM driver, select for “Network
Directory/CDROM” and set “Source Host Name...”.
Select “OK”. Select the ACC Base Software and any other ACC items
to be installed, from the list of software bundles; open the “Actions” menu and
select “Mark for Install”. When all items have been marked, select “Install
(analysis)”; select “OK” and proceed.
| | | |  | NOTE: A final Confirmation message informs you that a new
kernel will be rebuilt using the filesets installed, and the system
will reboot. When you are ready, select “Yes”. | | | | |
The “Install (analysis)” window allows you to
track summary progress of the installation process. Use the “Logfile” feature
to display a detailed status, which is logged to /var/adm/sw/swagent.log. | | | | | NOTE: Before starting the ACC Base software installed on a
Multiplexer interface, you MUST run ioscan -f to
verify that the driver nacc0 (nacc1 for 4-port cards or nacc2 for 8-port PCI cards) has claimed
the newly-installed card in the desired slot. Then ACC software start-up can proceed
normally. Otherwise contact your HP Support representative. | | | | |
|
Printable version
