Introduction

This section provides the results of actual Data Analyzer sessions that were run using this software. The sessions were run on both a 4-Channel T1/E1 multiplexer and on an 8-Channel multiplexer.

Both an X.25 session and an ISDN session are described for the 4-Channel multiplexer. But because the 8-Channel multiplexer was not designed to provide ISDN service, only an X.25 session is described for this product.

General Procedures

The process involved with all sessions described in this appendix is generally as follows:

Ensure that the ACC multiplexer hardware and its base system and X.25 software are properly installed (per supplied manuals );
Ensure that the X.25/ACC configuration has been properly set up: refer to the X.25/ACC Installation and Configuration Guide as needed;
Start up the ZCOM muliplexer subsystem (described below);
NOTE: In the case of the 4-Channel T1/E1 sessions the ISDN subsystem is also started up, as described below.
Establish an X.25 connection via the ACC Multiplexer (described below);
NOTE: In the case of the 4-Channel T1/E1 sessions the X.25 connection is made over an ISDN call set-up as described below.
Send packets over the connection using the X25Check utility (described below);
Run Data Analyzer's pdisplay program to observe trace of the captured file.

These sessions were run with the HP-UX utility Script executing in the background, to preserve a trace of all terminal activity involved with the procedures.

Introduction

Technical documentation

» Table of Contents

» Index

General Procedures