- ZLU.#
This is the ZLU number of a port assigned to the
Data Analyzer. These ZLUs are recognized by the application number
being set to 90 in the network configuration file.
- MX P
This shows the mux number and port number within the
mux that the ZLU # is connected to.
- Sub
This shows the sub-channel number within the mux and
port number that the ZLU # is connected to.
- Typ
The Port must be either a DTE or DCE. This identity
is setup in the network configuration file. If the port is configured
as a DTE then the Y-cable port labeled TX monitor should be connected
to it, if it is a DCE port then the RX monitor cable should be connected
to it. See the configuration section for more details.
- AZLU
This is the partner ZLU, which should also appear
in the display. The partner ZLU must be a different type (DCE if
this ZLU is a DTE, and DTE if DCE).
- Mode
The mode field gives the action that pcapture takes when the capture file is full. It may be Halt or Wrap. If Halt is indicated then the analyzer will halt when the file
is full; if Wrap is indicated then the file will be overwritten with
new data.
- Stat
This is the current state of the analyzer which
may be either run or stop.
- LC.M
This shows that the LCN numbers are being used for preprocessing
filtering. Refer to the “run” command for more details.
If no LCN filters are set then this field displays none and all traffic is captured to the file, otherwise Yes is displayed and only the traffic for LCN numbers specified
in the run command are saved into the file.
- Size
This is the current maximum file size in bytes.
- Name
This is the name of the capture file specified in
the run command or the default file name if no file was specified.
The default file name is of the form /var/opt/acc/log/anz_ZLU.eve, where ZLU is the ZLU number used in the run command.
Printable version
