stopd

The stopd command stops the analyzer and deletes the analyzer ZLUs in use provided that they were dynamically configured by previous use of the runc command.

Format

stopd card port [subchannel]

Description

This command stops the protocol analyzer on the specified card, port and (if an applicable card type is in use) subchannel.

pdisplay then deletes the corresponding pair of analyzer ZLUs.

This command cannot be used to delete analyzer ZLUs statically configured in the network (ttgen) configuration file.




	NOTE: Be sure that you intend to DELETE the ZLU pair on the specified mux/port/subchannel. If you only intend to halt the analyzer, use the stop command.

stopd

Technical documentation

» Table of Contents

» Index

Format

Description