Requirements and Considerations

OS Versions Supported

The ACC SNAPlus2 Link Software product supports HP-UX 11.0.

ACC Hardware Supported

The ACC Base Software product and the ACC and X.25/9000 Software Bundle product may be ordered to use with the following ACC hardware products:

8-Channel HP-PB (NIO) ACC Multi-channel Interface
8-Channel EISA ACC Multi-channel Interface
8-Channel PCI ACC Multi-channel Interface
2-Channel HP-PB (NIO) ACC Multi-channel Interface

Pre-requisite Software

You must have the following products already installed on your computer before you start the SNA/ACC installation procedure:

SNAplus2, version 6.0
ACC Base Software, version 3.02 or later
or
ACC and X.25/9000 Software Bundle, version 3.02 or later

Usage

The SNAplus2 features can be used with multi-channel ACC products over SDLC and over X.25.

Using SNA Over SDLC

To use SNAplus2 over SDLC with the ACC cards, the SNAplus2 software product, the ACC Base Software and the ACC SNAplus2 Link Software must be installed on your system.

Using SNA Over X.25

To use SNAplus2 over X.25 with the ACC cards, both the SNAplus2 and the X.25/ACC products must be installed on your system. The SNA/ACC product is not required.

ACC Hardware Not a Pre-requisite

It is not a requirement that you install your ACC cards first before installing the pre-requisite ACC software mentioned above or the ACC SNAPlus2 Link Software. You may install the ACC software first, and then install your ACC cards later on.

However, in the case of the pre-requisite ACC software, if you install your ACC cards after this software has been installed, then you will need to do some configuration to update this installed ACC software to recognize these new cards. For details on this, refer to the ACC Installation and Configuration Guide that is provided with the ACC Base Software product, or the X.25/ACC Installation and Configuration Guide that is provided with the ACC and X.25/9000 Software Bundle product.