Checking SNAplus2 Status

If the new kernel has booted successfully (Chapter 2, Section Software Installation, Step #8), the SNAplus2 software is probably running. Use the following command to check for the status of SNAplus2 on your system:

/opt/sna/bin/X11/xsnapadmin

	NOTE: Use of xsnapadmin requires Motif interface software and a bit-mapped display to run X11. Use snapadmin as an alternative if necessary.

The xsnapadmin window appears as shown in Figure 3-1 “xsnapadmin Window”. If the SNAplus2 software is not running, issue the following command to manually start SNAplus2:

/opt/sna/bin/snap start

If this is unsuccessful, refer to the HP-UX SNAplus2 Installation Guide for detailed procedures.

Figure 3-1 xsnapadmin Window